Two Open Source Projects Combine to 3D Print a Working Replica Key Using a Flipper Zero
3DPrinting
5
Posts
3
Posters
0
Views
-
This post did not contain any content.
-
This post did not contain any content.
the key is laid flat against the Flipper Zero's display and the depth of each cut on the screen moved to match its physical equivalent. This provides a series of "bitting" numbers, which can be used to cut a working copy of the key.
Neat!
-
the key is laid flat against the Flipper Zero's display and the depth of each cut on the screen moved to match its physical equivalent. This provides a series of "bitting" numbers, which can be used to cut a working copy of the key.
Neat!
Yeah! Just like using a block of cheese!
-
Yeah! Just like using a block of cheese!
-
mmm, cheese
The cheaper FlipperZero alternative that can give you the shits, too! Switch today!
